American Made Brewhouses: Quality Construction

All brewhouse tanks and heads are made of stainless steel with a #4 finish. Metal inert gas (MIG) process is used on all exterior welds and food grade tungsten inert gas (TIG) process is used for all interior welds. All outer skins are polished stainless steel with TIG welds. All vessels are insulated double wall construction, creating a very energy efficient system. All brew houses are fully assembled and tested in our shop prior to shipment to site.

Brewhouse Components


Our standard 30 barrel brewhouse offering includes a 30 barrel steam fired brew kettle matched up with a 45 barrel hot liquor tank and 30 barrel mash tun. The brew kettle has tangential side port for optional whirlpool process following the boil. The vessels are oversized so the brewer can deliver a full 30 barrels of wort to the fermentation vessels.  Stainless steel dimple jackets are utilized on the vessels to maximize steam energy transfer into the wort, decreasing wait time before boiling. All three vessels are fitted with internal clean in place ball system.

All pumps, valves, heat exchanger, and process piping are included to provide a complete system.

Grant/Hop Back

Our 25 gallon grant/hop back provides an accessible location to take wort samples during the lautering process. The grant is also used by many brewers to dry hop their wort after the boil is complete. High and low level sensors inside the vessel control the main transfer pump to maintain the correct flow in the process. The grant/hop back has a removable wedge wire false bottom for easy cleaning and sanitation.

Brewers Platform

The brewer’s platform is custom fitted to match each brewhouse system. Made from a perforated, non-slip fiberglass material the brewing platform allows the brewer easy access to the control panel and manways on top of the vessels. The brewhouse system has been designed to minimize elevation and only requires three steps from ground to top of platform.

Control Panel

The brewing control panel allows the brewer to set HLT temperature setpoint and monitor mash tank and brew kettle temperatures. Transfer pump mode and speed are also controlled at the panel. Each control panel is built in the USA, prewired and tested in our shop, and is UL listed for the specific job location.